About
I build battery-powered sensor products end to end: the circuit board, the firmware that runs on it, and the path through certification into production.
At EVident Battery I lead hardware, firmware and manufacturing for a vibration-sensor line used in EV battery diagnostics; I joined as an Electrical Engineer in 2025 and was promoted to Associate Engineering Manager in 2026. Before that, at Purdue, I designed boards for senior design, the ECE teaching labs and the SoCET team, and set the electrical architecture of two IEEE ROV vehicles while leading the team that designed their boards.
Outside work: 3D printing, mechanical keyboards, and the occasional Pro-level Sudoku.
Experience
Associate Engineering Manager, EVident Battery
Apr 2026 to present
I lead hardware, firmware and manufacturing for EVident's IoT vibration-sensor product line.
- Designed a register-level I2C driver and an interrupt-driven FIFO drain for 6,666 Hz IMU acquisition, sustaining 30-minute recordings with zero lost samples.
- Cut sensor idle current by about 95 % with the radio off, using power management guided by a Nordic PPK2.
- Led the firmware for the EVB-01 Pro on ESP-IDF and FreeRTOS in C++20, including the release and the device API reference.
- Built host unit tests with fakes for FreeRTOS, lwIP and flash, plus a bench test runner for automated hardware campaigns.
- Built the encrypted firmware release and update path, including production flashing.
- Took the product through CE RED, FCC Part 15B and ISED ICES-003 testing as the test lab's contact.
Electrical Engineer, EVident Battery
Mar 2025 to Apr 2026
I designed and shipped the company's first sensor product, EVB-01, owning its hardware, firmware and documentation.
- Wrote the production EVB-01 firmware: Arduino C++ on FreeRTOS tasks, on the ESP32-S3.
- Built the GoogleTest suite and the NimBLE GATT link for a BLE gateway that commands low-power sensors.
- Designed and brought up the ESP32-S3 vibration sensor board, with a six-axis IMU and Li-Po charging, through several revisions, including moving the IMU from I2C to SPI for higher sample rates.
- Designed a low-power BLE sensor, and a four-layer USB-PD charging board with a PD sink, a charger and a fuel gauge.
- Designed three half-bridge motor-driver boards for a shaker test rig, and wrote its control software.
Electrical Engineering Intern, Milwaukee Tool
Jun to Aug 2024
I designed a capacitor-disconnect circuit that cuts the inrush when a battery is inserted, and the STM32 firmware that switches it on.
- Wrote STM32 timer-interrupt firmware in IAR that switches a capacitor-disconnect circuit on once the microcontroller has started.
- Designed a capacitor-disconnect circuit behind a power MOSFET for a cordless tool's control board, where battery insertion drew up to 280 A. It cut the typical inrush by about 46 %, and the same fix stopped connector arcing on a rotary hammer.
Education
BS Electrical Engineering, Purdue University
Skills
- Hardware
- KiCad, Altium Designer (internship), LTspice, hardware bring-up, power management and USB-PD charging, EMC and radio certification (FCC, ISED, CE), oscilloscope and SCPI automation, Nordic PPK2.
- Firmware
- C, C++, Python, FreeRTOS, ESP-IDF, ESP32-S3, STM32, BLE, Wi-Fi, I2C, SPI, UART, GoogleTest, encrypted firmware release and update.